| /* |
| * Copyright (C) 2010 The Android Open Source Project |
| * |
| * Licensed under the Apache License, Version 2.0 (the "License"); |
| * you may not use this file except in compliance with the License. |
| * You may obtain a copy of the License at |
| * |
| * http://www.apache.org/licenses/LICENSE-2.0 |
| * |
| * Unless required by applicable law or agreed to in writing, software |
| * distributed under the License is distributed on an "AS IS" BASIS, |
| * WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied. |
| * See the License for the specific language governing permissions and |
| * limitations under the License. |
| */ |
| |
| /* This structure starts 16,384 bytes before the end of a hardware |
| * partition that is encrypted, or in a separate partition. It's location |
| * is specified by a property set in init.<device>.rc. |
| * The structure allocates 48 bytes for a key, but the real key size is |
| * specified in the struct. Currently, the code is hardcoded to use 128 |
| * bit keys. |
| * The fields after salt are only valid in rev 1.1 and later stuctures. |
| * Obviously, the filesystem does not include the last 16 kbytes |
| * of the partition if the crypt_mnt_ftr lives at the end of the |
| * partition. |
| */ |
| |
| #include <cutils/properties.h> |
| |
| /* The current cryptfs version */ |
| #define CURRENT_MAJOR_VERSION 1 |
| #define CURRENT_MINOR_VERSION 2 |
| |
| #define CRYPT_FOOTER_OFFSET 0x4000 |
| #define CRYPT_FOOTER_TO_PERSIST_OFFSET 0x1000 |
| #define CRYPT_PERSIST_DATA_SIZE 0x1000 |
| |
| #define MAX_CRYPTO_TYPE_NAME_LEN 64 |
| |
| #define MAX_KEY_LEN 48 |
| #define SALT_LEN 16 |
| |
| /* definitions of flags in the structure below */ |
| #define CRYPT_MNT_KEY_UNENCRYPTED 0x1 /* The key for the partition is not encrypted. */ |
| #define CRYPT_ENCRYPTION_IN_PROGRESS 0x2 /* Set when starting encryption, |
| * clear when done before rebooting */ |
| |
| #define CRYPT_MNT_MAGIC 0xD0B5B1C4 |
| #define PERSIST_DATA_MAGIC 0xE950CD44 |
| |
| #define SCRYPT_PROP "ro.crypto.scrypt_params" |
| #define SCRYPT_DEFAULTS { 15, 3, 1 } |
| |
| /* Key Derivation Function algorithms */ |
| #define KDF_PBKDF2 1 |
| #define KDF_SCRYPT 2 |
| |
| #define __le32 unsigned int |
| #define __le16 unsigned short int |
| #define __le8 unsigned char |
| |
| struct crypt_mnt_ftr { |
| __le32 magic; /* See above */ |
| __le16 major_version; |
| __le16 minor_version; |
| __le32 ftr_size; /* in bytes, not including key following */ |
| __le32 flags; /* See above */ |
| __le32 keysize; /* in bytes */ |
| __le32 spare1; /* ignored */ |
| __le64 fs_size; /* Size of the encrypted fs, in 512 byte sectors */ |
| __le32 failed_decrypt_count; /* count of # of failed attempts to decrypt and |
| mount, set to 0 on successful mount */ |
| unsigned char crypto_type_name[MAX_CRYPTO_TYPE_NAME_LEN]; /* The type of encryption |
| needed to decrypt this |
| partition, null terminated */ |
| __le32 spare2; /* ignored */ |
| unsigned char master_key[MAX_KEY_LEN]; /* The encrypted key for decrypting the filesystem */ |
| unsigned char salt[SALT_LEN]; /* The salt used for this encryption */ |
| __le64 persist_data_offset[2]; /* Absolute offset to both copies of crypt_persist_data |
| * on device with that info, either the footer of the |
| * real_blkdevice or the metadata partition. */ |
| |
| __le32 persist_data_size; /* The number of bytes allocated to each copy of the |
| * persistent data table*/ |
| |
| __le8 kdf_type; /* The key derivation function used. */ |
| |
| /* scrypt parameters. See www.tarsnap.com/scrypt/scrypt.pdf */ |
| __le8 N_factor; /* (1 << N) */ |
| __le8 r_factor; /* (1 << r) */ |
| __le8 p_factor; /* (1 << p) */ |
| }; |
| |
| /* Persistant data that should be available before decryption. |
| * Things like airplane mode, locale and timezone are kept |
| * here and can be retrieved by the CryptKeeper UI to properly |
| * configure the phone before asking for the password |
| * This is only valid if the major and minor version above |
| * is set to 1.1 or higher. |
| * |
| * This is a 4K structure. There are 2 copies, and the code alternates |
| * writing one and then clearing the previous one. The reading |
| * code reads the first valid copy it finds, based on the magic number. |
| * The absolute offset to the first of the two copies is kept in rev 1.1 |
| * and higher crypt_mnt_ftr structures. |
| */ |
| struct crypt_persist_entry { |
| char key[PROPERTY_KEY_MAX]; |
| char val[PROPERTY_VALUE_MAX]; |
| }; |
| |
| /* Should be exactly 4K in size */ |
| struct crypt_persist_data { |
| __le32 persist_magic; |
| __le32 persist_valid_entries; |
| __le32 persist_spare[30]; |
| struct crypt_persist_entry persist_entry[0]; |
| }; |
| |
| struct volume_info { |
| unsigned int size; |
| unsigned int flags; |
| struct crypt_mnt_ftr crypt_ftr; |
| char mnt_point[256]; |
| char blk_dev[256]; |
| char crypto_blkdev[256]; |
| char label[256]; |
| }; |
| #define VOL_NONREMOVABLE 0x1 |
| #define VOL_ENCRYPTABLE 0x2 |
| #define VOL_PRIMARY 0x4 |
| #define VOL_PROVIDES_ASEC 0x8 |
| |
| #ifdef __cplusplus |
| extern "C" { |
| #endif |
| |
| typedef void (*kdf_func)(char *passwd, unsigned char *salt, unsigned char *ikey, void *params); |
| |
| int cryptfs_crypto_complete(void); |
| int cryptfs_check_passwd(char *pw); |
| int cryptfs_verify_passwd(char *newpw); |
| int cryptfs_restart(void); |
| int cryptfs_enable(char *flag, char *passwd); |
| int cryptfs_changepw(char *newpw); |
| int cryptfs_setup_volume(const char *label, int major, int minor, |
| char *crypto_dev_path, unsigned int max_pathlen, |
| int *new_major, int *new_minor); |
| int cryptfs_revert_volume(const char *label); |
| int cryptfs_getfield(char *fieldname, char *value, int len); |
| int cryptfs_setfield(char *fieldname, char *value); |
| #ifdef __cplusplus |
| } |
| #endif |
| |